https://photos.smugmug.com/Primary-G...Rep%202-X3.jpg
Liche's Wrath parts. In the ened I did it as four prints - the main hull, the upper and lower wings and the lower pylon. It actually took more like eight hours than below six, but it meant it was one fifty minutes and three just-over-two-hour prints. Which means less problems if you frack it up.
Which I did, of course, and only realised AFTER I'd started sticking it together that I'd managed to skip subtracting the post hole solid on the main hull. Still, in the
'Wrath's specific case, it hardly matters, since it stands on it own anyway...!
https://photos.smugmug.com/Primary-G...Rep%202-X3.jpg
https://photos.smugmug.com/Primary-G...on%2002-X3.jpg
https://photos.smugmug.com/Primary-G...on%2001-X3.jpg
https://photos.smugmug.com/Primary-G...on%2003-X3.jpg
Took a couple more goes before I had the
Subterfuge and
Frostbeam to my satisfaction. The first try I got the horizontal dimentions about right, but they looked like they'd been squashed; took two more iterations before I got them to more like a sensible height.
Subterfuge Scoutship
https://photos.smugmug.com/Primary-G...parison-X3.jpg
Frostbeam Corvette
https://photos.smugmug.com/Primary-G...parison-X3.jpg
The biggest annoyance was actually trying to plonk it on something that was about the right height to the old model - which naturally, was a height that nothing would actually come close to without actually basic properly (which I don't have time for today, though I nearly might as well have) - in the end, I bluetacked it onto the backdrop holder...!
And for reference: Here's One I Made Earlier, the Shadowfang (Mk 1) I did ages ago as a test to see how possible it was to do this sort of thing
https://photos.smugmug.com/Primary-G...on%2001-X3.jpg
https://photos.smugmug.com/Primary-G...on%2002-X3.jpg
Gonna start updating the rest of the old scratch-built ships as I get some free time between moderns stuff, at least until I get some ground force ideas.
(Also there are dark rumours about a Mk 2 Enrager, but that havfe to wait until I can get some more than theorhetical discussions...!)